Rhino HDGS96

Grading Scraper HDGS96

Double tap to zoom



The Rhino grading scraper cuts material from high spots and deposits it in the low spots, leveling the surface. Available in widths of 60", 72", and 84", this scraper will fit your needs with a minimum number of passes over the surface.

Designed for economical use, the grading scraper only requires 30-50 HP, depending on model. Additionally, heat treated shanks with replaceable hardened tips that can rip down 2-3/8" are standard on every Rhino Grading Scraper!

The offset angled blades use 1/2" x 6" cutting edges that are reversible and replaceable for long life, and the 13-3/4" tall side panels allow for large volume movement of loose material. Full length replaceable wear skids are standard for long life in tough conditions!


  • Smooths gravel driveways, roadways, and parking lots by cutting material from the high spots and moving it to the low spots.
  • Uses two offset angled blades with ½" reversible and replaceable cutting edges for long life
  • Category 1 hitch and quick hitch compatible for easy hook up
  • Tall side panels allow moving large volumes of material without leaving spill out ridges.



Working Width 96"
Tractor HP 90 - 2WD 72 - 4 WD
Blades 2, Angled
Cutting Edge ½" x 6" bolt-on,replaceable,reversible heat treated
Side Panel Thickness 3/16"
Skid Shoe 1/2" x 2- 1/2 x 52" long
Hitch CAT 1 & 2 QH
Front Frame Beam 4" x 4" x 3/8" Wall
Rear Frame Beam 4" x 4" x 1/4" Wall
No. Shank Position 3/4" x 2-1/2" x 19 1/8" 4 holes, Heat Treated Plow Point
No. of Shanks 8
Approximate Weight (lbs) 828